Filter by tags
Questions, Articles and Polls
2 Likes
·
1 Answer
A:
No. ChemTec One is a reactive silicate concrete densifier. It actually creates a by-product that becomes part of the concrete matrix. It increases the mass, density, compressive strength, and abrasion resistance. It is in the concrete, not on the
... more
2 Likes
·
1 Answer
A:
Sheet products have seams and overlaps where water can seep in. If a sheet product is punctured, water can run under the damaged membrane and leak out elsewhere. GacoFlex LM-60 elastomeric coating forms a seamless, impermeable coating that is 100%
... more
2 Likes
·
1 Answer
A:
Not currently, as no products that we know of meet the .05 emissivity requirement of the code. The coatings that we are familiar with have an emissivity of between .25 and .3. Most builders use roof sheathing that comes with the radiant barrier
... more
2 Likes
·
1 Answer
A:
Unquestionably, the corrosion resistance is better using pre-painted metal than metal from a typical post-painted product. Due to the superior cleaning and treating of the strip during the coil coating process, the priming of both sides and the
... more
2 Likes
·
1 Answer
A:
To improve both the vision through the lenses and the appearance of the glasses, an antireflective coating (also called AR coating) is applied. AR coatings are similar to the coatings found on microscopes and camera lenses. They consist of several
... more
2 Likes
·
1 Answer
A:
Another lens treatment that is beneficial but invisible to the naked eye is ultraviolet (UV) protection. Just as we use sunscreen to keep the sun's UV rays from harming our skin, UV treatment in eyeglass lenses blocks those same rays from damaging
... more
1 Like
·
1 Answer
A:
With a single base coat and 2 top coats of resurfacing compound applied the surface may build up to approximately 2-5mm over the existing concrete.
... more
2 Likes
·
1 Answer
A:
Yes. It's called X55 HI-SEAL paint. Another Geo®Paint, this Ability surface coating product similar to the Paint typically gives a natural looking cementitious (cement-like) matte, flat, basically smooth finish. Just like the Paint, X55 HI-SEAL is
... more
2 Likes
·
1 Answer
A:
The EPOX-Z High Performance Coatings can be applied as thin as 4 mils in a single coat, or built up to 65 mils.
... more
2 Likes
·
1 Answer
A:
There are many factors that go into the cost of a floor system - from existing conditions of the concrete, substrate thickness, or the coating system. Special details are also available, such as line striping, decals or logos, cove base and wainscot.
... more
1 Next