Filter by tags
Questions, Articles and Polls
2 Likes
·
1 Answer
A:
There are alternatives available at both the base and head of partition walls. Either of the two base treatments can be used with either of the two head treatments: 1) Internal partition walls can be constructed either; a) directly off the floating
... more
2 Likes
·
1 Answer
A:
No. For engineering reasons, the center duct chase opening must remain close to the physical center of the truss. Beginning July 1, 1996 new ANSI standards went into effect for wood floor truss design. ANSI standards do not allow the duct chase to
... more
2 Likes
·
1 Answer
A:
Solid 2x joists are cheaper on a per unit basis. However, studies have shown that by the time culls, waste and labor are considered, a more superior TrimJoist™ floor system could have been installed. In addition, since TrimJoist™ products use 2x4
... more
2 Likes
·
1 Answer
A:
18mm solid wood flooring can be laid to joists at 400mm centers. However Floorwise strongly recommend first laying a load-bearing timber based sheet material such as plywood first. This will greatly improve the performance of the floor and avoid
... more
2 Likes
·
1 Answer
A:
You may notice that the second or third floors in your home are sagging or leaning. Finding the solution doesn't have to be expensive. Fortunately, you can raise the floor joists in the basement of your home by using a jack. This is a slow process,
... more
Q:
We have owned our home for 20 years and our kitchen floor is sinking. A builder inspected it and said that there are several floor joists that need to be repaired because there was a fire before we purchased our home and these joists were not prope
... more
2 Likes
·
1 Answer
A:
Yes they are supported by a 6 inch by 6 inch timber placed vertically from the top of the foundation to the bottom of the sub floor. This transfers the bulk of the weight of the home directly to the foundation and not just on framing members.
... more
2 Likes
·
1 Answer
A:
Residential use requires 16” on center. Click here for more information on the installation of PC Ultima.
... more
1 Like
·
1 Answer
A:
Version(s): 10, 11 The joists have been added to the drawing using the Joist Poly command. To change the direction, you need to change the edge which is being used as the Joist Reference edge. The Reference Edge is denoted by the double red XX. To
... more
2 Likes
·
1 Answer
A:
If you're building a house or adding on a room, you must lay out floor joists once the basement walls are up. Joists are supports upon which the subfloor is placed. These run from the sill to the girder, which you place halfway between the outside
... more
1 Next