Can AutoPIPE run a flange check and if so, how?
Yes, AutoPIPE can run a flange check. In the flange dialog box check “ANSI Check”, select the flange class and material and select the gasket material. AutoPIPE automatically runs the flange check. Question 84: I am looking at a tutorial for water hammer called apham1. I have noticed that between A06 and C00 there is, essentially, a split between the supply and discharge lines of the imaginary pump (each is anchored and flanged). I didn’t know this could be done. Could you help me to get this same type of arrangement set up for a similar project I am working on? Answer: Select the suction nozzle where you want to add a discharge nozzle. Press F3 and note the coordinates. Using your pump drawing calculate the coordinates of your discharge nozzle. Go to Insert/Segment and set the first point number (i.e if new segment is C then first point would be named C00), and input the discharge nozzle coordinates. Insert you anchor and proceed. Note: If the pump is changed or if you need to adjust
Related Questions
- The game installed OK, but when I try to run the game I get an error that reads "General Protection Fault: History: Init_Engine" And then the launcher quits. Whats wrong?
- How I can determine if a flange in the piping system is under tension or compression with AutoPipe?
- What days and hours will it run?
