For those of us with existing engine monitors from Dynon, will the new generation products be backwards compatible with the connector and sensors?
COMPATIBLE: All engine and temperature probes, AOA/Pitot probes, Autopilot servos, encoder converter module NOT COMPATIBLE: EDC-D10A remote magnetometer, mounting brackets and trays, expansion modules (HS34, AP74 – see below for details) Engine harness pinouts are expected to remain the same*, but primary wiring harness pinouts will be different. • While you can plug an existing EMS-D10 / EMS-D120 harness into a SV-EMS-220, the SV-EMS-220 makes use of some pins differently. One example is that the serial port pins used for the EMS-D10 / EMS-D120 are general purpose inputs on the SV-EMS-220; these changes are thoroughly explained in the SkyView Installation Manual. You may also have to remove some inline resistors that were required for the EMS-D10/EMS-D120/FlightDEK-D180.