How can I avoid the whole screen being filled when I open a picture using the OpenPicture function via LoopInAlarm?
For this, you must make the following settings in the Alarm Logging Editor. Under “Message blocks” you select the user text blocks that are supposed to flash. Open the Properties and activate the check box marked “Flashing On” (see Fig. 01). Fig. 01 As from WinCC V5.x you can make this setting also directly in the Graphics Designer in the Properties of the Alarm Control. However, you should note here that these settings might only be valid for this one particular OCX and thus lose their central modifiability. WinCC V5.x and WinCC V6.0 Double-click the OCX to open the properties of the WinCC Alarm Control and switch to the “Message blocks” tab. In the Properties of the relevant message texts, you activate “Flashing On” in the “User text blocks”. If, on the Alarm OCX, the “Accept project setting” check box is activated in the “Message blocks” tab, then any change to the user text block is stored directly in the CS database. If, however, the “Accept project setting” check box is not activ