How do I remove and replace the rear wheel bearing for a 2004 ford mustang gt?
SECTION 205-02B: Rear Drive Axle/Differential — Ford 8.8-Inch Ring Gear 2003 Mustang Workshop Manual IN-VEHICLE REPAIR Axle Shaft Removal Raise and support the vehicle. For additional information, refer to Section 100-02 . Remove the wheel and tire assembly. For additional information, refer to Section 204-04 . Remove the rear brake disc (2C026). For additional information, refer to Section 206-04 . Remove the differential housing cover (4033) and drain the lubricant. For additional information, refer to Differential Housing Cover in this section. Remove the differential pinion shaft (4211). Remove the differential pinion shaft lock bolt (4241). Remove the differential pinion shaft. CAUTION: Do not damage the rubber O-ring in the axle shaft groove. Remove the U-washer (4N237). Push the axle shafts (4234) inboard. Remove the U-washer. CAUTION: Damage to the rear brake anti-lock sensor (2C190) may occur if it is not removed before the axle shaft. Carefully remove the rear brake anti-lock