How do I remove the motor on a TDC30P/N/S/YS Condenser Tumble Dryer ?
• To the best of our knowledge the following information is correct and sufficient for the purpose intended. However we accept no responsibility for any omissions, losses, damage, or injury however caused either directly or indirectly by using the information gained from these instructions. The motor on the Hotpoint TDC30 is held in place by two screws securing the mounting to the under side of the cabinet. However it is also linked to other components via the impellor and shaft. First remove the top cover and right hand side panel then tilt the machine backwards (or lay it on its back). Undo the two motor bracket retaining screws and stand machine upright again. Rotate the drum so that an indented section is directly over the top air duct moulding and unclip both sections, swing the upper section of the moulding out of the way out side the cabinet. You can now remove the belt from the jockey pulleys. Take off the heater cover and remove the hose clip and impeller from the motor shaft.