how do i remove the right side hand grip to replace with a new one?
The right side handgrip is the throttle sleeve assembly and grip combined. To get it out, first, adjust both the throttle cable and the idle cable (both cable going into the throttle assembly) to give you as much slack as possible. Loosen the two bolts that hold the front brake master cylinder on and move the master cylinder towards the center of the handlebars just a bit. The remvove the two bolts that hold the right handlebar switch housing together. Carefully move the top half away. There are a lot of wires in this housing and you don’t want to break or pinch any of them. Now, you can see the round part of the throttle sleeve and where the cables connect to it. Each of the cables has a ferrel on the ball on the end of the cable. Do not lose these ferrels. Work each of the cables with the ferrell out of it’s hole in the throttle sleeve. Lower the bottom half of the switch housing and remove the throttle sleeve from the handlebar. Now, before installing the new sleeve, lubricate the h