How Do You Attach The Red Dot Finder To Your Meade 8N Lightbridge Truss Tube Dobsonian Telescope?
A Meade 8-inch LightBridge truss tube Dobsonian telescope is a great system to view the stars with at any time of night. You’ll be able to see virtually any of the stars in the sky. Rather than the traditional crosshair configuration, it comes equipped with a red dot finder. With it, you can align the telescope easier. Follow these steps to find out how attach it to your Meade 8-inch LightBridge truss tube Dobsonian telescope. Make sure the base is resting on its feet. The rubber feet should be on the floor. Verify that the entire assembly will move up and down easily. Verify that the entire assembly will move easily left and right. Verify that the eyepiece is installed on the telescope. Assemble the red dot finder. Slide the red dot bracket on top of the dot finder scope. Locate the two hex screws. Tighten them with the hex wrench that comes with your telescope. Find the red dot mounting groove on the telescope. Slide the red dot finder bracket over the OTA mounting groove. Align the
Related Questions
- How Do You Set The Blink Rate Of The Smartfinder Red Dot On The Meade LX90GPS Schmidt-Cassegrain Telescope?
- How Do You Attach The Red Dot Finder To Your Meade 8N Lightbridge Truss Tube Dobsonian Telescope?
- How Do You Align The Red Dot Finder Of Your Meade 8N Lightbridge Truss Tube Dobsonian Telescope?