How Do You Change A Serpentine Belt On A '95 Jeep 2.5L?

Add your answer...

1 Answer

• Lean over the radiator. The power steering pump is on your right. • Take careful note of the routing of the old belt. There should be a diagram sticker around the fan shroud, otherwise draw a good diagram. • Loosen the 3 bolts on the back of the pump bracket. Do not take them out! • Loosen the small bolt underneath the pump. Under the power steering pump there it a long adjusting bolt that screws out to your right and a small bolt perpendicular to it at the front side. Loosen the small bolt to the front then screw out the bolt out to the right about 1 inch. • Remove the old belt. • Install the new belt with exact same routing. • Screw the long bolt back in under the PS pump to obtain proper belt tension. You should use a belt tension gauge. Tighten the 3 bolts on the back of the PS pump and the one bolt under the PS pump that is to the front. more
Thanks for your feedback!

Related Videos

Not the answer you're looking for? Try asking your own question.

Related Experts

Gary Hill
Cars expert
John Canali
Cars expert