How Do You Make A Braided Duct Tape Bracelet?
10 steps to a better you (aka you with a duct tape bracelet)! This is an interesting and unique bracelet that you could also make into an anklet if you wanted to. • Whip out your duct tape and some scissors. • Cut a strip of duct tape about 8-10 inches long(you may have to get a longer piece or a shorter piece depending on your wrist size). • Cut the duct tape into thirds lengthwise, so that you have three long stringy pieces of duct tape. • Stick two of them somewhere so they don’t get messed up. Then take the third one and twist it so that most of the sticky side is twisted inwards so that you have a usable, almost non-sticky piece of duct tape. • Do the same with the other two pieces. • Cut off a little piece of duct tape, about a half an inch long. • Take all three of the strings and tape all three ends in a bunch ( just like you would knot the strings before braiding). • After you have that done that, begin braiding. If you don’t know how, I’m sure there’s an article somewhere, bu