How Do You Make A Butterfly Knife?
There’s no reason to purchase an expensive kit or waste time on trial-and error projects. With this simple step-by-step guide you can make a beautiful butterfly knife the first time you try! Make the handle. Measure the palm of your hand. Add approximately 5mm to determine the length for the handles of your knife. Cut two half handles to the desired length. Once the wooden handles are at the desired length, sand them down to enable them to rotate in the main shaft without difficulty. Note: sanding will affect the main design of the handles, so use caution. Drill a hole through the top semi-circle of the handle with a 5.5mm drill bit. Incorporate a 1 or 2mm rut at the top of the shaft. This is needed to allow the blade itself to rotate. Make this rut so that it is about 2.5cm long, and straight through the middle of your handles on the opposite sides of the drilled holes that you completed in step 2. Add a blade. Make a rotation section on the blade so that it can move 180-degrees withi