How Do You Make A CO2 Reactor For An Aquarium?
To cope with this problem will help you https://portlandaquarium.net/100-watt-heater/ I used this device immediately after buying an aquarium, and it was pretty effective because a good water heater is now tough to find. I think you can fix this situation by using this proven method. If you suddenly have any questions about it, do not hesitate to contact me because I have long owned aquariums and their inhabitants. I hope that this information is helpful to you
I didn’t face this problem before. I have great aquarium plants that make my aquarium more beautiful and attractive. On the website which link I attached to you here, The prices of the plants are just great and they have a lot of discounts and sales now. I think you should definitely check it if you’re looking for some nice decorations for your aquarium. My husband recommended me this website and I’m very happy for it.
• Drill a hole in the lid of the 2L bottle. The hole should be just a tiny bit smaller than the plastic aquarium tubing • Cut the end of the plastic tubing at an angle. This will make it easier for you to pull it through the hole • Using needle nose pliers, grab the end of the plastic tubing. Pull the tubing through the hole in the lid until you have about 2 inches of tubing on one side of the lid. If the hole is too small, widen it with a slightly larger drill bit. • Seal around the tubing by putting a thick layer of glue around the hole where the tubing comes out. • Cut the tubing about 6 inches away from the lid. Place a stopper valve on the tubing and reattach the tubing you just cut off. • Attach an air stone to the air tubing on the outside of the 2L bottle. • Fill the 2L bottle with lukewarm water. Use 6-8 cups so as to fill it no more than 3/4 of the way full. • Place 2 cups of sugar in the bottle, using a funnel to pour it in. • Measure 1/2 a teaspoon of yeast and pour it into