How Do You Make A Duct Tape Cell Phone Case With A Belt Loop?

0
Posted

How Do You Make A Duct Tape Cell Phone Case With A Belt Loop?

0

• Get duct tape. Two colors if you want. • Measure your phone lengthwise then add 1/2 inch to each end. • Measure it sideways. • Once measured, make a small sheet of “fabric” that is as long as (plus 1/2 an inch on each end) and twice as wide as your phone. But remember, the color doesn’t matter because it will eventually be covered up. Put it aside. Do not fold yet! • Now take two strips about 4 inches long and place them together with the non-sticky side out. • Fold it in half. • Now get your sheet of duct tape fabric and fold in half so your phone can fit in sideways. • Take the belt loop strip and put it directly in the middle of the sheet. • Make sure that the loop has one flap on each side. • The loop can be as big as you want it to be, but there has to be enough space for a secure grip. • Take the colored tape that you want on the inside and run it from left to right (or right to left) (so the sides of the tape are in the corners of the case) on both of the halves of the inside

Related Questions