How Do You Make A Duct Tape Ipod Pouch (Nano Second Generation)?
• Measure on a piece of paper the width and height of your iPod. Then measure the end, the height again, and the end once more on top of you height measurement. Then you can measure a “flap” height on top of that as well. • Cover the area you measured with duct tape, front and back. • Cut out the area you covered with scissors. • Measure the heights again. Then cut the first layer of duct tape with an X-acto knife, or another kind of razor knife. This side is the inside part of the case. • Fold the cut lines so they cut in inward. • Take a piece of duct tape the height of your iPod and cut it in half. Put one piece on the outside with less than half the piece attached to the case. Take the other half and cover half the glue side on the inside of the case. Repeat this for the other side of the case. • Pull the sides up and tape them together. • Fix any sides that are not even by simply putting another piece of tape over it. Cut a hole in the top of the case where the “flap” is to allow
