How Do You Make A Lego Rubber Band Gun?
• Gather the necessary LEGO pieces: this model requires several technical pieces, but many of them could be substituted. • Build the main shooting mechanism: it’s designed so it can be loaded with 8 rubber bands and shoot one at a time at each pull of the trigger. • Construct the beam that will extend from the mechanism to hold the front of the rubber bands. The piece furthest towards the front that the rubber band loops around should be pointed straight forward. • Imagine you are shooting a rubber band with your fingers. Your thumb in front shouldn’t be straight up and down, with the rubber band right around the middle. That would cause you a lot of pain, and the rubber band wouldn’t go anywhere. So, point the tip of the gun that holds the rubber bands straightforward, and do the same with your thumb. • Make a handle: make it however you want, but make sure no parts of it interfere with the mechanism. • Load the rubber bands: loop them around the front beam, around the small gear in t