How Do You Make A Water Balloon Launcher With Plastic Tubing?
In a water balloon fight the advantage of a water balloon launcher is a very helpful in winning any water balloon war. There are many different ways to make these launchers, and they can also be purchased at stores. However, in many cases the store bought ones are not as good as the homemade versions. These instructions are based on using flexible plastic tubing, but other tubing such as surgical tubing or rubber tubing can be used as well. Step 1 The base shape for the bag for the balloons is a giant plus sign. The approximate measurements should be a 14-inch square, but it can be made smaller or larger if desired. Cut out the square and then cut out about 3-inch by 3-inch squares from each corner. The end result will be a giant plus sign. Step 2 Lay out the two wood pieces onto opposite tabs of the cloth. Take the duct tape and wrap the wood pieces inside the pockets of cloth by folding over the ends of the cloth towards the middle of the cloth. Use a lot of tape so that the wood is
