Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

How Do You Make An Air Rifle Scope Detachable?

0
Posted

How Do You Make An Air Rifle Scope Detachable?

0

• Remove and measure the screws that hold the scope to the rifle body. These were M4 by about 7mm. • Buy longer screws, and springs to match, that will fit the same tapped holes in the scope mount. These are M4x25mm with compression springs labeled #3 at the local hardware store. • Tighten the screws so that the spring is tight, but still has enough room for compression that you can remove and reattach the scope. • Holding the movable (spring-loaded) mounting tabs in place, snap on the scope so that the fixed pieces are also in the groove. • Slide it forwards or backwards so that the scope is always in the same place. Here you see that the place where the primary lens screws onto the scope tube is lined up with the rear sight. • Sight-in the scope, even if you already did so before the modification. This will have to be done every time your remove and reattach the scope. To remove the scope, push against it so the springs compress. Lift off the far (fixed) side, and then pull towards y

0

• Remove and measure the screws that hold the scope to the rifle body. Remove and measure the screws that hold the scope to the rifle body. These were M4 by about 7mm. • Buy longer screws, and springs to match, that will fit the same tapped holes in the scope mount. Buy longer screws, and springs to match, that will fit the same tapped holes in the scope mount. These are M4x25mm with compression springs labeled #3 at the local hardware store. • Tighten the screws so that the spring is tight, but still has enough room for compression that you can remove and reattach the scope. • Holding the movable (spring-loaded) mounting tabs in place, snap on the scope so that the fixed pieces are also in the groove. Holding the movable (spring-loaded) mounting tabs in place, snap on the scope so that the fixed pieces are also in the groove. • Slide it forwards or backwards so that the scope is always in the same place. Slide it forwards or backwards so that the scope is always in the same place. Her

Related Questions

What is your question?

*Sadly, we had to bring back ads too. Hopefully more targeted.