How Do You Make An Electric Herbal Vaporizer?
Herb vaporizers release resins from leaves and buds by heating, rather than burning, the herb. Heating the resins turns them from a gummy substance to liquid vapor. Vaporizers eliminate inhalation of smoke. They use either conduction of heat directly on the herb or convection of hot air over the herb. Vaporizer users have devised several plans for homemade vaporizers. Most are unsightly, but you can construct a dressed-up conduction vaporizer. Cut the board into five lengths of 7 3/8 inches each. Bevel the ends of four lengths at 45 degrees. Glue and clamp two of the beveled pieces flush at opposite ends of the fifth section. Let the glue set. Glue and clamp the last two lengths to the unbeveled length and and at the same time glue and clamp all the beveled edges. Stain the box and paint the edge of the food jar lid. Drill five holes in the lid: one the diameter of the soldering iron handle where it meets the heat end in the center of the lid, one the diameter of the nylon tubing off c