How Do You Nail Down Roll Roofing?
Roll roofing has enjoyed unchanged popularity over the years due to its exceptionally high performance and durability – this coating has been serving for more than 25 years provided it is properly installed. Roofs equipped with rolled materials have a relatively low cost since their prices are an order of magnitude lower than alternative types of finishes. In addition, the material is fastened rather quickly. Metal roofing in Toronto it’s a good choice
Roll roofing is by far the easiest type of roofing to install. This is why so many people choose roll roofing over other types of roofing material. However, there are other advantages to roll roofing, including that it can last up to 12 years. But despite the lack of difficulty involved with installation, there are still a few potential problems that an aspiring roofer might encounter. Perhaps the most common issue might be the best way to nail down the roofing itself. Make sure that the roof is completely clean. Cover the valley of the roof. The valley of the roof is the point on the roof where the two sides meet. The entire length of the valley should be covered with a sheet of roll roofing that is at least 18 inches wide. Nail down the 18-inch roll roofing sheet that it is covering the valley. The nails should start 3/4 inch from the edges of the roofing and be 6 inches apart throughout the roofing’s surface. Trim any roofing that extends beyond the edge of the roof. Place a sheet o