How Do You Remove The Front Access Panel Of A Frontload Kenmore Washer?
The homeowner needs to know how to remove the front access panel of a front load Kenmore washer when electrical components inside need to be tested. Unlike a standard washer cabinet, the Kenmore front load washer will require that the top panel be removed. This procedure can be performed by the average homeowner in under an hour using basic hand tools. Unplug the front load Kenmore washer from the wall outlet. Cut off the water supply by turning the spigots off that supply water to the washer. Place a bucket underneath the area where the water hoses are connected to the Kenmore washer. Disconnect the water hoses from the washer by turning them counterclockwise. Place the ends of the water hoses in the bucket to prevent spilling residual water on the floor. Pull the front load Kenmore washer away from the wall so you can access the rear of the unit. You need enough room behind the washer to pull the top panel off of the unit. Go behind the washer and remove the three hex head screws tha