How Do You Repair Mobile Home Plumbing Water?

0
Posted

How Do You Repair Mobile Home Plumbing Water?

0

Mobile Home plumbing is a bit different than house plumbing, but do not fear it is much easier. Step 1 Find the ONE water shutoff valve. It should be near your hose hookup. It will be the ONLY water inlet for the entire mobile home. After you find it TURN OFF THE WATER. Step 2 Locate your leak. If it is coming from the faucet itself it will need to be replaced, as it is a one (1) piece faucet. If it is coming from the line (pipe) it will be clear. Clean the pipe and mark it with a pen. Step 3 Take your saw out and use the mark you made to identify where to cut. Make a cut about an inch above the mark. One the pipe is free take the saw and cut it again about an inch below the mark. Step 4 Now take and clean both ends of the pipe you have left. Make sure there are no burs or filings in or on the ends. Wipe ALL water from the outside AND inside. Step 5 Now take the fitting you have (should be a female – female) and slip it over the end of the pipe from the sink side. Than slip in the loos

Related Questions