How Do You Repair Whirlpool Washer Parts?

The Whirlpool washer coupler takes the place of the belt that is used on the older style washers. If your washer does not agitate or spin, there is a good chance the coupler is broke. The best way to change the coupler is to remove the cabinet. This is easier then it sounds. The first thing you need to do (after disconnecting the power) is to loosen the control panel. There are four different designs. The most common control panel is held in place to the cabinet with two screws at the base of the panel, on the right and left edge. The next common style is there are two screws on the backside of the panel on the right and left side. The third design is there are trim pieces attached to the control panel on each end. These trim pieces will pop off with a simple tug at the top After you remove the trim, you will find two screws in the front corners. The newest design is that there are spring style clip under the end caps of the control panel. You can release these clips with a butter ...  more