How Do You Replace A 5Th Generation Ipod Battery?
• Be sure to turn your hold switch ON before beginning repair. • Insert a curve tipped plastic pry tool in the seam between the plastic front and metal back of the iPod. Run the tool along the seam and gently push in on each of 5 clips to free the first side. It is helpful to use your index finger and your thumb to put pressure on each clip you are trying to pry. • Continue to slide the pry tool around the corner seam and release the single tab near the hold switch. • While holding the freed side together, release the 5 tabs along the opposite side of the iPod. You may be able to free these tabs by gently wiggling the front panel of the iPod. Do not rip the cover open. • Be aware of the two orange ribbons connecting the body of the iPod to the rear panel. You will first disconnect the ribbon at the bottom of the iPod. Use a nylon stick (or spudger of any type) to slide up the brown connector that holds the ribbon in place. Lift the brown locking bar up about 2mm to free this cable. • U