How Do You Replace A Belt In A Creda Tumble Dryer?
The steps to replacing the belt on your creda tumble dryer. Hey All, This doesn’t appear to be a simple task so I would suggest making sure you have the time to do this so your project does not get interrupted. 1: Remove power (better now than later 😉 ) 2: Remove the front door assembly (2 screws holding the hinge to the drier carcase) 3: Remove the top cover (2 screws at the rear, then slide the top backwards and lift off). It’s a good idea to remove any fluff from the innards at this point. 4: Lay the drier carefully on it’s front (I used a pillow to protect the timer and 2 pushbuttons) 5: Remove the cover over the drum bearing and earth strap (2 screws) 6: Remove the cover over the fan assembly (numerous screws) 7: Remove the earthing bracket (copper assembly held by 2 small screws) and then remove the circlip and washer on the drum axle 8: Remove the fan vanes (3 hex screws holding 2 metal flanges that make up the impeller fan) 9: Remove all screws around the rear cover and gentl