Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

How do you replace the CV Joints on a 1990 Honda Accord?

CV Honda joints replace
0
Posted

How do you replace the CV Joints on a 1990 Honda Accord?

0

To replace the boot and/or halfshaft axle: First, remove the wheel cover and loosen the 36mm nut holding the joint to the bearing. Then raise the vehicle and remove the lower ball joint from the lower control arm and the knuckle. If your working on the passenger side, drain the transmission. Slide the half shaft out of the knuckle then use a prybar and pry the inboard end of the shaft out of the transmission or intermediate shaft, which ever should apply. Be careful not to damage the seal in the transmission. Installing the shaft is the reverse of removal. The inboard side of the shaft should snap right back into the intermediate shaft and transmission by means of a snap ring on the end of the shaft.

Related Questions

Thanksgiving questions

*Sadly, we had to bring back ads too. Hopefully more targeted.