How Do You Split A Satellite Cable?
Satellite signals do not work the same way as cable feeds. With a small charge (13-18 volts) from the receiver to the satellite’s low noise blocker on the line, a conventional splitter will cause too much signal drop, resulting in a total loss of picture in most instances. Adding a larger multiswitch if LNB outputs are exhausted is the only way to achieve additional signal feeds. Remove the typically installed 4×8 multiswitch from the satellite installation, by unscrewing all coaxial connections. Label the input feed with a fine-tip marker. Screw in the 4×16 multiswitch in same manner as the 4×8 unit was connected. Connect the input feed to the appropriate input, and the individual coaxial feeds from the outputs. Route the additional RG-6 coaxial cables to the required areas. The second feed is used for dual-input satellite digital video recorders, or to feed additional rooms. Screw on the coaxial cables next to each other, labeling the wires with the fine-tip marker.