How to boost power Poulan chainsaw 4620AVHD?
I mean if you need to boost the power, maybe you should start looking for a new one. It depends on how much use you want to get out of the tool, cause if you only want to have it sitting somewhere in case you might need it one day, then maybe some tips and tricks on increasing the power might work. However, if you want to actually keep using the tool in day-to-day life, then I stand by my point and say that it might be better to just look for a new one, ’cause it’s gonna give up on you anytime and that’s a pretty annoying feeling. I just had it happen with my old miter saw table and now I’m looking at articles to make an idea about what miter saw stand I should buy that will last me ages.
I think the answer to your question should be in the guides, which tell you in detail about chainsaws. I would advise you to contact a service center(if your warranty is still valid), or a workshop where such things are repaired. Have you heard of tacklife? I think if you’re interested in it, you’ll find it interesting. I used my chainsaw for a very long time until it stopped working(it was in excellent working condition for seven years) and after it broke down, I decided that it was time to open for myself such a thing as laser jij saw
I have a poulan 4620AVHD with nothing but problems. Been serviced twice while it was under warrenty.Worked fine then died again. I’ve pulled carb cleaned.Have L mix screw out 2.5 and H mix screw out about 1.5 turns. It starts and runs at idle fine, my problem is that it seems not to have power at full throtle. If I adjust the H mix screw any difient the saw won’t start.