How to replace the power steering belt on a 2000 mazda 626?
First and foremost, make sure you have a diagram before removing the old belt. If there isnt one under the hood, get out the pencil and paper and draw it out labeling the pullies and arrows pointing to the direction the belt travels on them. Save this paper in the glove compartment when the job is done for future reference. As far as replacing goes, it depends on the engine. Believe it or not, they are different amongst manufacturers, makes and models, so Bclear! If there is a spring loaded tensioner, youll need to turn the tensioner back to relieve pressure, and slide the belt off the tensioner pulley. Depending on the tensioner, you may be able to use a socket wrench with the right socket, 3/8 drive with socket wrench, or in some cases, youll need a tool that is meant for just this called a belt tensioner wrench. After it is relieved of tension, the belt can be removed. The new one gets routed the same, if you cant remember, refer to your diagram. If you didnt make one and cant remem