I am using CSA with the 10/100 full-duplex adapters, connected to a tap. Whats the difference between the Full Duplex Pass Through and the Full Duplex Forward, and which one should I choose?
Under [Configuration]->[Adapter Settings] page, choose ‘Full Duplex Pass Through’ when using a tap. In this mode, the cards terminate the signal from both monitor ports on the tap as it arrives at the cards, so the card sees all traffic but the traffic does not flow through the cards themselves. In the ‘Full Duplex Forward’ option, the cards themselves capture and forward all traffic received on one card out the other (and vice-versa). Use this option when not using a tap.
Related Questions
- I am using CSA with the 10/100 full-duplex adapters, connected to a tap. Whats the difference between the Full Duplex Pass Through and the Full Duplex Forward, and which one should I choose?
- How is the Cadillac Area Youth Orchestra (CAYO) connected to the CSA?
- Can BotHunter be used with an Ethernet Tap to monitor full-duplex.?