Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

I finished KeyScan installation, how do I check if the KeyScan keyboard and internal built in USB2 hub are functional?

April 26, 2017built finished Functional Hub installation Internal keyboard keyscan usb2

0

Posted

I finished KeyScan installation, how do I check if the KeyScan keyboard and internal built in USB2 hub are functional?

1 Answer

0

Posted

• Make sure the KeyScan KS810 is connected to your PC with the KeyScan original USB2 cable. • Turn on your PC and let windows finish startup process. • Look at the rear connector panel of the KS810 (right where the USB cable is connected to the KS810 unit). • Near the USB cable connector you should see a small hole, inside the hole you should see Green blinking light, this blinking light indicates the on going USB communication between you KS810 and the PC. • In case you do not have such blinking light- • Try to disconnect the USB cable from the KS810 (if the power cable is connected disconnect also the power cable). • After 10 seconds reconnect the USB cable ad the Green light should start blinking within 10-20 seconds. • If you still do not have the blinking light try to restart your PC and repeat the above process. • After you do see the blinking Green light, open any word processing application and try to use you KeyScan keyboard.