A:
1 Answer
rank
1
|
A. The Hydraulic flow is controlled by pressure feed back, so until the new hoses are full of oil, the pump will try to instantly go to full flow. Close the flow control to the new hoses and start the engine, then slowly open the flow control until the hoses are full of oil. Do not forget to top up the oil level afterwards.
more
|
nonentry.com
Related Videos
Add your answer...
Top Answerers
1.
2.
3.
Top Askers
1.
2.
3.
Top Supporters
1.
2.
3.
I fitted new hoses to the lobe pump and now the engine stalls as soon as I start the power pack, what am I doing wong?
Related Questions
- Yes. Seal-Krete Original Waterproofing Sealer can be used on Durarock before installation of tile and grout ...
- The StEPP Foundation maintains wide discretion on how, to whom, and when those funds are reallocated. First ...
- One of Best Cob LLC Horse Bedding's most appealing qualities is that you no longer have to remove large ...
- A person with a disability who has a state issued disabled indentification card or license plate can park in ...
- The Interlock allows a free restart of two minutes. The vehicle can be restarted within this time without ...