I have a 2005 bmw X5 and no manual, what is the procedure to program your garage door opener to the buttons?
Martin is correct, you wouldn’t have found this procedure in the manual anyway. It came with the UGDO (Universal Garage Door Opener) itself when it was purchased and installed. But the exact same thing is at the website. Basically you hold the button for several seconds until it flashes, then hold your remote up to it and press its button. However, if you have a rolling code opener, it is a little different. Also, if the button you want to use already has a code in it, you will have to delete it. To do this, you have to delete all the old codes. That is in the procedure also. Here is a simple run down which would probably work for you, but double check. 1. For first time training, press and hold the two outer HomeLink buttons, releasing only when the HomeLink indicator light begins to flash after 20 seconds. (Do not perform this step when training the additional HomeLink buttons.) 2. Hold both the handheld transmitter button and the HomeLink button you would like to program until the H
