I haven got an existing water filtration system and the tap diverter does not fit my tap what can I do – what is the easiest way of connecting / fitting to my water supply ?
The easiest way is to fit a water faucet onto your cold water supply. This can be done in a variety of ways depending on what you want to spend. Two options are self fit systems, which would include another filter in line for large particulate and so protect your investment in the Masterpiece, these come complete with a water faucet and all fittings for connection to the mains cold water supply. The diagram opposite shows how the faucet is installed. These pre-fit systems fit under the worktop / surface area. Most DIY / Handymen can fit these with very little trouble under 1 hour. Put simply, drill a 3/8inch hole in worktop, two holes for filter clamp / housing, put a clamp on mains water, attach push on pipe fittings / pipes, screw in plunger to pierce mains water supply pipe, finished. If you cannot or dont want to do a self-fit system then a plumber or handyman would be able to connect to the mains without too much trouble.
Related Questions
- I haven got an existing water filtration system and the tap diverter does not fit my tap what can I do - what is the easiest way of connecting / fitting to my water supply ?
- Can I fit a Hills ESTEEMâ„¢ Evacuated Tube Solar Hot Water System to my existing hot water system?
- Can Simply PUR water filtration system be connected to an existing faucet installation?