I just installed an X-Drive starter, hooked up the starter cable, turned the key and nothing happened. Whats the problem?
It sounds as though the solenoid is not being energized when the starter system is being engaged. I would recommend checking to verify there is a 16 gage jumper wire between the power terminal where you connected your starter cable and the small spade terminal between the two large terminals. This will supply power to the solenoid which will close the contacts, allow battery power to flow to the motor and mechanically engage the drive gear into the engine ring gear.
Related Questions
- I have installed a copy of ISE software 6.2i that shows Platform Cable USB as a selectable configuration tool. Why does the cable not work properly?
- I recently installed an E-Drive starter and it stays engaged for three or four propeller rotations and then disengages. What could be the problem?
- I added a video extension cable to my system and now the image appears blurry. What happened?