Icon Vehicle Dynamics Suspension Question: Will the Icon Vehicle Dynamics 2.5″ lift system level my 05-06 F250 Superduty?
The Icon Vehicle Dynamics 2.5″ kit was initially designed for F350s, as such when installing the kit on a F250 the truck will sit nose high. We recommend adding either a 1″ rear block, replacing the 2″ F250 block with 4″ flat block or an OE 3.625″ F350 block. Making this change will address the rear shock length issue as well though we do recommend rotating the lower shock mounts down a bit when adding only the 1″ block. In order to rotate the passengers side lower shock mount down you will need to remove it and elongate the hole in the mount which fits over the centering pin on the axle housing. Elongating the upper side of the hole roughly ” will allow you to rotate the shocks position down approximately 1″. For the drivers side you will need to unbolt the lower mount and remove the centering tab located inside. The mount can then be relocated allowing the shock to be extended approximately 1″ as well. This modification will allow you to properly run the DR Signature Series rear shoc
Related Questions
- Icon Vehicle Dynamics Suspension Question: Why doesnt the Icon Vehicle Dynamics 4.5" lift system for the 05-06 Superduty include a drop track bar bracket and pitman arm?
- Icon Vehicle Dynamics Suspension Question: Can I use Icon Vehicle Dynamics Coil-Overs in conjunction with any other lift system?
- Icon Vehicle Dynamics Suspension Question: Will the Icon Vehicle Dynamics 2.5" lift system level my 05-06 F250 Superduty?
