Id like to perform a capture using only one channel of my full-duplex setup. How can I determine which of the two ports (channel) is the primary used for a single end-node capture?
To determine which of the two ports (channel) is the one used by ClearSight in single end-node capture mode follow these steps: 1) Open the ‘Network Connections’ window in Control Panel. 2) Select ‘Thumbnails, Tiles, or Icon’ under the ‘View’ menu. 3) Unplug any network cables from both ports. 4) Check the ‘ClearSight 10/100 Full Duplex’ connection. You should see a red ‘X’ through its icon. 5) Plug in the live network cable into one of the ports. 6) If the red ‘X’ disappears, you have just found the primary port. This will be the one used by ClearSight when capturing in single end-node mode. If the red ‘X’ does not disappear, then the other port is the primary.
Related Questions
- Id like to perform a capture using only one channel of my full-duplex setup. How can I determine which of the two ports (channel) is the primary used for a single end-node capture?
- What criteria/tests were used to determine the historical authenticity/accuracy of the primary biographical sources?
- What are the primary aspects used to determine a ship models appraisal value?