Is it possible to set a trigger event on errors such as CRC errors?
Yes it is possible to set a trigger on a CRC error. The user needs to set the trigger to a combination term of CRC = 1 and Error = 1. This will capture either a header or data CRC error. The error bit is set when a bad CRC is detected. Q. I find the bit of ERROR at 3bit of Pod1, Appendix A: Format Definitions page27. If we set the trigger on ERROR=1 and run, is it possible to trigger when one of the errors occurs described as error messages in page 20,21? As a suggestion for a future revision, can we focus on and select the type of each error by setting the trigger? ANSWER: Most of the errors mentioned on pages 20-22 are actually detected by the IA, so the error bit will not be set. The error bit (POD 1 bit 3) is set for the following conditions.