Radio Controls, Receivers, Servos, etc How to test servos if I have no radio?
Batteries, Soldering, Maintenance Heat removal while soldering lipo Question – How Do I tune my model engine? I messed up the factory setting. How do I setup my low end needle Answer Here are some tips to make you an expert at tuning model engines . FIRST – Don’t play with the settings on a new engine, because the manufacturer will have put the optimum settings on already. We can reset the fast settings ok if they are messed up. But we cannot reset the idle settings properly until after the engine runs in and loosens up, allowing it to idle unhindered by the new tightness all new engines have We can only guesstimate fair idle settings to a certain degree on a new engine. then later on after running in, we fine tune the idle until it is at optimum. So if you mess up the idle settings on a new engine, you will probably have it a bit harder to deal with for the first 30 minutes to 2 hours run time. What follows is how you proceed if everything is totally “played with” and “messed up” on a
