Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

THAT CMOS KEYER LOOKS GOOD, SO HOW ABOUT SOME TIPS FOR USING IT?

CMOS good keyer looks tips
0
Posted

THAT CMOS KEYER LOOKS GOOD, SO HOW ABOUT SOME TIPS FOR USING IT?

0

Sure. After the usual playing with the functions and some practice, do this for easier HSCW operation. Make a little card showing the /U codes for the various HSCW speeds (1000 lpm – /U20, 4000 lpm – /U80, etc.). Then put a piece of masking tape or a slip of paper in front of the 6 memory buttons for labels. (For HSCW, here’s mine – #1, calls. #2, calls, report. #3, R, report. #4, RRR. #5, 73. #6, open). Also, on your sked sheet, put the Bank (and, if different, the memories) to use for each station. Since you can’t tell for sure what you are sending, you *must* use some memory aids for this or any similar memory keyer. Even so, you will occasionally find yourself sending the wrong data, for we ALL have done this. Use all 3 banks, one bank for each sked. Or, if you are running several skeds at the same speed, memories #4 & #5 would be the same, so you could have even more skeds set up ahead of time. #3, the report, can probably be set up ahead of time. Unless it is near the peak of a s

Related Questions

Thanksgiving questions

*Sadly, we had to bring back ads too. Hopefully more targeted.