What are the features of DSI compared to other sensor interfaces (such as CAN, LIN, Flex Ray and PSI5)?
* LIN bus is a low speed (20kbps) single wire single master multiple slave network SCI communication network. All transactions are initiated by the master. Additional nodes can be added or removed from the bus without physical changes to the node hardware. * CAN bus is a medium speed (125kbps on single wire to 500kbps on a 2-wire balanced line) protocol. The CAN protocol provides bus arbitration at the physical layer through recessive and dominate bit-states on a bit by bit basis with lower numbered address having higher priority. Quartz-based clocks are required at all nodes (CSMA / CSMA-CD). Carrier sense multiple access with collision detection * FlexRay is a high speed (2.5 to 10Mbps), dual channel, multi-master distributed system architecture which offers deterministic communication to support safety-critical applications. FlexRay facilitates reduced wiring compared to parallel CAN networks when employed as the vehicle wide network backbone. Highly complex control modules and phys