0
Q:

What are the steps for removal of the multi function switch on my 2007 Dodge Dakota Laramie?

Answers

0
Answer REMOVAL WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment. 1. Disconnect and isolate the battery negative cable. 2. Remove the screw (2) that secures the tilt steering column knob (1) and remove it from the tilt actuator (3) on the left side of the column. 3. From below the steering column, remove the two outboard screws that secure the upper column shroud (1) to the lower shroud (3). 4. Using hand pressure, press inward on both sides of the upper shroud above ... more
Write a comment...
Thanks for your feedback!

Related Videos


Not the answer you're looking for? Try asking your own question.

...