What are the torque specs for the Quickdraw?
The head bolts need to be torqued to 15 inch pounds exactly. We have a special preset torque wrench that is fool proof available. You need this if you plan on removing the head button. 6) Can I check to see if my crank is straight on a lathe? This method is OK so long as you know that your chuck has No run out. Put a straight shaft in the lathe chuck, something about the same diameter as the crank (12mm), check it right at the chuck and then go out about 3″ from the chuck and see what you have. If both readings are no more than .0005, this is good. When you are checking your crank, check it right where the main bearing goes and then go right out to before the magneto taper and check it there. The run out should be the same as it was at the main bearing location. If it’s not, you will have to look at where it is high versus where the crank pin is at to know if the crank needs to be hit, squeezed or wedged. You can not do it between centers because the centers in the crank are not accura
