What causes bubbling in the finish of a project coated with Rust Bullet?
The Three most common reasons for bubbling are: Applying Rust Bullet too thick. As Rust Bullet cures, small gas bubbles can get trapped in overly thick areas of the coating, creating bubbles in the finish. When using a brush or roller, Rust Bullet should be applied evenly without buildup in a crosshatch method (an up and down, side to side continuous motion). Prematurely applying a subsequent coat over a partially wet previous coat will trap the escaping gas during the curing process causing bubbles in the finished coating. Shaking the can creates air bubbles in the product. Prior to application, Rust Bullet must be stirred thoroughly until completely uniform and homogeneous (approximately 3 minutes). Shaking the container may cause the formation of bubbles in the finish of the coating. Avoid whipping air into product. Do not use electric or mechanical mixing devices that will whip air into the product.