What command shows what TX and RX frequencies are configured other than the show run command? What other valuable information does this command provide?
A. The show controller r4/0 rf command shows what TX and RX frequencies are configured. The following is a sample output and some of the important things to look at in this output: Headend# show controller r4/0 rf RF ODU# 1 Hardware Identification Info: PIC code version: 0.15 !— This shows the point in call (PIC) code version that is !— currently on the ODU. !— This is important if you encounter problems with the ODU. NVS checksum 0x69 NVS version: 0.0 Card type: 0x10 Vendor name: cisco Part number: 800-05805-03 Board number: 73-4352-03 HW rev code: 03 Serial number: JAB041904BZ Date code: 05112000 RF ODU# 1 Hardware Capability Info: Capability flag1: 0x9F Capability flag2: 0x2C RF Diversity Head: Tx/Rx Tx Blanking Capable: Yes RF Power Level Mode Capable: Yes RF Power Gain Mode Capable: Yes RF Loopback Capable: Yes Tx Predistortor Capable: No Antenna Alignment Capable: No PA Temp Sensor Capable: Yes Tx Spectral Inversion: No Rx Spectral Inversion: No Rx Blanking Capable: Yes Rx
- What command shows what TX and RX frequencies are configured other than the show run command? What other valuable information does this command provide?
- What is the problem if I don get AP TX 20, AP RX 20, SU RX 20 for response from su testrflink < suid > command?
- My DirecWay unit shows a different Rx or Tx code. What does this mean?