What is the best and most accurate method of setting up my HHO generator using the included electrolyte?
Better way to setup MagDrive HHO generators to avoid over heating problems after long periods of operation. IT ONLY TAKES 1/2 GALLON OF WHITE DISTILLED VINEGAR TO MAKE 3.5 – 5 AMPS FOR SETTING UP AND FILLING THE HHO GEN. Keep in mind the initial charge amperage should be 3.5 – 5 amps and once warmed up, at full operating temp the amperage should be appx 7 – 11 amps. The unit has a 15 amp fuse for protection of over amperage which limits the operating temp from exceeding the maximum allowable temerature. Do not exceed the operating temp of 150*F, or alter the electrolyte mix ratio or eliminate the 15 amp protection fuse, either “WILL” result in causing a melt down on the anode post. You must turn off the HHO gen when exiting the vehicle, if you do not it will boil out the electrolyte, drain the battery and make it difficult to re-start your engine. We strongly advise getting an ADD-A-CIRCUIT to power your HHO gen, it can be purchased at any auto supply store for appx $7. By setting up y