What is the method for controlling the “arc on function” of the hand held torch option?
All plasma cutters are different. On some you can tie into the trigger circuit inside the power source, on others there is a pigtail near the base of the hand torch lead where it enters the power source and then on others you have to tie into the trigger wires right in the torch head and run them back to tie into on/off relay. Our tech guys know most of the tricks. There are a lot of cutters out there. There is a contactor/relay in the control system that closes to signal “arc on”, if we connect the torch “arc on” wires circuit to it. When it comes to the Router, Plate Marker/Engraver, Oxy-Fuel, Glue gun, etc, it will be a separate relay box. $550 is for our z-axis includes that relay box with 110v outlet. Even though a lot of people just leave the router on the whole time. When it comes to many of the other accessories, you can’t just turn it on when you start a program and leave it on. It needs to turn on and off throughout the program like the torch, except those accessories need po
