Whats the process for determining a problem with a PostScript-mode printer, in particular a KODAK DIGITAL SCIENCE 8650 PS Color Printer, that is on an APPLETALK installation?
• Are both the computer and the printer set for the same ETHERTALK phase (Phase 1 or 2)? • Has the APPLETALK/ETHERTALK network driver been selected in the network dialog box? • If the name of the correct printer driver (for example, the DS 8650 PS Printer Driver) does not appear as a selection in the Chooser, verify that the printer driver was properly loaded on the host. Check for the existence of a file called Kodak DS 8650 PS in the System Folder’s Extensions folder. If the host driver software is not there, install it according to the instructions in the software user’s guide. • Does the printer’s name appear as a selection in the Chooser? (The factory default name for the 8650 PS Printer, for example, is “KODAK DS 8650 PS.”) If not, check the following: • Make sure that APPLETALK is enabled (the Active button in the Chooser should be selected). • Make sure that the printer has been on for at least three minutes. • If the printer is installed on a network with multiple zones, check
Related Questions
- Whats the process for determining a problem with a PostScript-mode printer, in particular a KODAK DIGITAL SCIENCE 8650 PS Color Printer, that is on an APPLETALK installation?
- Whats the process for determining a problem with a printer on a NOVELL NETWARE installation?
- The setup of the digital pictures recovery creating problem during installation process?
