Why do I get a Mismatched Simulink version warning?
This warning is issued when you load a model that was created with a version of Simulink that differs from the version that Reactis is configured to use. There are a couple of ways to eliminate the warning. • Configure Reactis to use the version of Simulink with which the model was created. Note, however that this solution changes the Simulink version used by Reactis for all models. Change the Simulink version used by Reactis as follows. • Start Reactis. • Select menu item File, Settings… • Select the MATLAB tab of the Settings dialog. • In the Use MATLAB version menu, select the version of MATLAB/Simulink used by the model. The versions of Simulink installed on your machine are listed in the menu. • Click Ok to save the change. • If the Simulink version used to create the model is older than the version used by Reactis, then you can convert the model to the version of Simulink that Reactis is configured to use. Do this as follows. • Start the version of MATLAB used by Reactis. • Loa