Filter by tags
Questions, Articles and Polls
2 Likes
·
1 Answer
A:
Because of the foam core, the beams are incredibly buoyant and capable of supporting substantial loads in water applications. A 6'x8' (1.8m x 2.4m) raft was capable of supporting over 1000 lbs (450 kg).
... more
2 Likes
·
1 Answer
A:
I'm not a chippy but cross banding or bridging is used to keep the joists parallel top and bottom and is achieved by nailing timber in between the joists top and bottom in a cross shape and prevent them from moving,solid bridging can also be used
... more
2 Likes
·
1 Answer
A:
In BS8110, it states that secondary reinforcement should be provided for beams exceeding 750mm deep at a distance measured 2/3 depth from the tension face. Experimental works revealed that at or close to mid-depth of deep beams, the maximum width
... more
2 Likes
·
1 Answer
A:
Open stirrups are provided principally to resist shear forces in concrete beams and they are applied in locations in which the effect of torsion is insignificant. U-shaped stirrups are placed in the tension side of concrete beams in which shear
... more
2 Likes
·
1 Answer
A:
The water equivalency of five "water-equivalent" solid phantom materials was evaluated in terms of output calibration and energy characterization over a range of energies for both photon (Co-60 to 24 MV) and electron (6-20 MeV) beams. Evaluations
... more
1 Like
·
1 Answer
A:
Yes, the minimum audit is two (2) photon beams (the lowest and highest energy, if you have more than one energy) and two (2) electron beams (lowest and highest energy). These beams can be from different machines. The RPC is not able to monitor
... more
2 Likes
·
1 Answer
A:
Like termites, woodworms are a wood boring insect that do a lot of damage to your home. They are especially hard to detect when they first come into a home because the adults, Furniture Beetles, lay their eggs on wood and the larvae then bore into
... more
1 Like
·
1 Answer
A:
You have to use the LOAD LIST command to achieve this. Supposing you want to check deflection for combination cases 81 and 82. And assume that L/Deflection has a limit of 240. The command sequence required to achieve this is LOAD LIST 81 82
... more
2 Likes
·
1 Answer
A:
This is permitted since the metal frame is only a secondary support to the primary wooden supports. According to some opinions, this is true only if the wooden beams are actually assisting in the support of the s'chach (i.e. the removal of the
... more
2 Likes
·
1 Answer
A:
On One Hand: Consistency is QualityGlulam beams are stronger than regular wood beams because the members composing the glulam are of higher quality than the whole of a regular wood beam; there are fewer checks, knots and other inconsistencies.
... more
1 Next